Label check
Voltage and amps read off the nameplate or manual, not guessed.
Dedicated Circuits
Dedicated Circuit Installation in Woodinville
Put the heavy appliance on its own breaker and stop the shared circuit from tripping every week.
Get a circuit added — (000) 000-0000
Two Big Loads, One Small Circuit
Heater and hair dryer. Air fryer and kettle. Garage freezer and shop vac. When a breaker drops every time two things run together, that circuit is carrying more than it should, and flipping it back on only buys time.
The fix is to give the heavy appliance its own breaker and its own wiring, matched to what it pulls. Many manufacturers insist on it in the installation manual, especially for cooking appliances, heat pumps and heavy workshop machines.
We start with the label on the appliance, confirm the panel has a free slot and enough headroom, and plan the shortest tidy route. If the panel is full, we lay out the realistic choices before quoting.
Buying more than one big appliance this year? Tell us about all of them, and we will plan the circuits as a set so the last one is not left without a slot.
What Goes Into It
Right size for the load. Right protection for the room.
Panel room
A free slot and spare capacity confirmed, with options if there is neither.
Wire and breaker matched
Copper gauge set by load and run length, paired with the right breaker rating.
120 or 240 volts
Single-pole for most appliances, two-pole for ranges, dryers, heat pumps and bigger tools.
Location protection
Ground-fault or arc-fault protection for garages, laundries, kitchens and similar spots.
Proper termination
The correct receptacle, or a hardwired connection and disconnect where the code wants one.
Clean run
Inside finished walls where possible, in conduit across garages and unfinished space.
Load test
The appliance switched on and the circuit measured before we sign off.
How It Is Done
Look and price
During the free visit we check the appliance, panel and route. Most single circuits are priced in writing there and then.
Install
A typical circuit takes a few hours. The rest of the house stays live while we work.
Test and label
Load test, breaker labelled, and the permit and inspection handled where required.
Why Call Us for It
Sized from the label
The circuit matches the equipment, not a rule of thumb.
Full panel? Options
Subpanel, rebalancing or tandem breakers, explained plainly.
Tidy job
Small openings, covered floors and a labelled breaker when we leave.
- Label readNot guessed.
- Load testedIn use.
- Priced on the visitFor most circuits.
- Breaker namedIn the panel.
Resetting the Same Breaker Again?
Tell us what you are running and what keeps cutting out. The visit is free and the price comes in writing.
End the tripping — (000) 000-0000